The attached patch modify the fdcboot source code to support wide
I needed to add some defines because :
- on some boards, the fdc registers aren't contiguous (for example they
can be aligned on a 32 bits boundary).
- the fdc chipset has a 8 bits data bus. Then, it can be connected on
the processor data bus on D0-D7 or D8-D15 or D16-D23 or D24-D31.
- the floppy drive can be on drive other than 0.
- some chipsets need extra initializations.
CFG_ISA_IO_STRIDE : defines the spacing between fdc chipset registers
(default value 1)
CFG_ISA_IO_OFFSET : defines the offset of register from address. It
depends on which part of the data bus is connected to the fdc chipset.
(default value 0)
CFG_FDC_DRIVE_NUMBER : the default drive number (default value 0)
If CFG_ISA_IO_STRIDE CFG_ISA_IO_OFFSET and CFG_FDC_DRIVE_NUMBER are
undefined, they take their default value.
if CFG_FDC_HW_INIT is defined, then the function fdc_hw_init() is called
at the beginning of the fdc setup. The function
fdc_hw_init must be provided by the board source code. It is used to
make hardware dependant initializations.
* Patch by Pierre Aubert , 05 Nov 2002
Hardware relative improvments in fdc booting
in message <3DC7F897.FA17CA3D at staubli.com> you wrote:
> The attached patch modify the fdcboot source code to support wide
> hardware designs
Added. Will show up on CVS in a couple of hours.
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd at denx.de
See us @ electronica 2002 in Munich, Nov 12-15, Hall A3, Booth A3.325